Mazak Integrex E500H-II
Datasheet verified · checked 17 Nov 2026 · Manufacturer datasheet ↗
| X travel | 870 mm |
|---|---|
| Y travel | 500 mm |
| C axis | Yes |
| B axis | Yes |
| Spindle taper | DIN 50 (50 taper milling spindle) |
| Spindle power | 30 kW (30 MINUTE RATING; 40.0 hp (main turning spindle)) |
| Tool capacity | 40 |
| Factory control | Mazatrol |
Notes
### Provenance Verified against Mazak Corporation's own INTEGREX e-500H II product page, captured by the Wayback Machine (the page has since been withdrawn from mazakusa.com): https://web.archive.org/web/20140830020431/https://www.mazakusa.com/machines/integrex-e-500h-ii/ Verified 17 November 2026 by reading the raw page markup. Figures below come from the machine's own specification table, which carries two columns - one per bed length. ### Bed length is not published The machine is built in two bed lengths and the published Z travel differs: the 1500U bed gives 1598 mm, the 3000U bed gives 3122 mm. The auction listing does not state which bed this machine has, so **Z travel is left blank rather than guessed**. Maximum machining length likewise differs: 1524 mm on the 1500U bed, 3048 mm on the 3000U. ### Spindle speed is not published The specification table gives two spindles: - Main (turning) spindle: 3300 min-1, 40.0 hp / 30 kW (30 minute rating) - Milling spindle: 10000 min-1, 50.0 hp / 37 kW (15 minute rating) The auction listing reports 1600 rpm, which matches neither figure. Mazak's own customer story describes INTEGREX e-500H-II units built with a high-torque 1600 rpm turning spindle, so this machine's turning spindle is an optioned build rather than the standard one. Publishing 3300 min-1 would describe a machine that is not the one for sale, so **spindle speed is left blank**. The published spindle power is the main turning spindle's 30 kW at a 30-minute rating. ### Other published values - Maximum swing 820 mm; maximum machining diameter 820 mm; main spindle chuck 15 in - Milling spindle is a 50 taper (DIN 50) - Tool magazine capacity 40 - C-axis driven by a drop-worm system with 0.0001 degree indexing - Control: MAZATROL Matrix 2 ### Conflicts with the auction listing - The listing reports 37 kW. That is the *milling* spindle's 15-minute rating (50.0 hp); the main turning spindle is 30 kW at a 30-minute rating. - The listing reports Y travel 250 mm against the published 500 mm. - The source page is itself inconsistent about the tool changer: the specification table gives a magazine capacity of 40, while the machine characteristics list 80 and 120 automatic tool changer options. The table figure is the one published. - The source is also inconsistent about B-axis travel - the machine characteristics give -30 to 210 degrees while the specification table gives 240 degrees. Only the presence of a B-axis is published, not a travel figure. ### Not published Machine weight, overall dimensions and rapid traverse rates are not stated anywhere in the source. No values are invented for them.